Selecting a channel
To tune to a channel using the User Control page:
1.Make sure that the AVT is in tune mode (see “Selecting tune or preset mode”, on the previous page).
2.Specify the channel number by any of the following methods:
•Keypad —
a.On the number keypad, click the but- ton for each digit of the channel num- ber. Use the hyphen
b.Click Enter on the keypad. The se-
lected channel number is displayed in cyan.
•Chan + and Chan – buttons — Click either of these buttons to increment or decrement the selected channel number.
•Previous Channel button — Click this button to select the previously selected channel.
•Channels menu — Select the desired channel number from the Channels
Selecting a preset
To select a preset using the User Control page:
1.Make sure that the AVT is in preset mode (see “Selecting tune or preset mode”, above).
2.Select a preset by any of the following methods:
•Keypad —
a.On the number keypad, click the number of the desired preset (1, 20, 32, and so forth; leading zeros are ignored). The numbers you click appear in orange in the display above the keypad.
b.Click Enter on the keypad. The preset number and name are displayed in cyan.
•Preset + and Preset – buttons — Click either of these buttons to increment or decrement the selected preset number.
•Previous Channel button — Click this button to select the previously selected preset.
•Presets menu — Select the desired channel number from the Presets
Adjusting the volume
In the Volume (%) section, you can increase or decrease the output volume by either of the following methods:
•Select the volume percentage (0 through 100) from the
•Click the – or + button to raise or lower the volume by one percentage point.
AVT 200HD Tuner • HTML Configuration and Control | 89 |
