Extron electronic manual Front Panel Features, AVT 200HD Front Panel

Operation

This section describes the AVT 200HD front panel controls and the procedures for using them to configure and operate the AVT tuner. Topics include:

•Front Panel Features

•Powering On

•Menus on the LCD Screen

•Resetting from the Rear Panel

•Locking and Unlocking the Front Panel (Executive Modes)

•Using the AVT 200HD IR Remote Control

Front Panel Features

1	2	3	4	5
			CHANNEL
IR			SDTV
			EDTV
	CONFIG		HDTV

6	7	8	9	10
					AVT 200HD
				VOLUME	ATSC TUNER
			ADJUST
	MENU	NEXT

Figure 12. AVT 200HD Front Panel

AIR receiver — This sensor receives commands via infrared signals from the optional AVT 200HD IR Remote Control (see “Using the AVT 200HD IR Remote Control,” later in this section).

BConfig port — Connect a USB cable (USB A to mini B) between your computer and this port to configure and control the AVT via SIS commands or the Windows-based configuration and control software, and to update the firmware.

CLED display — This 5-digit, alphanumeric LED display indicates the over-the-air TV or CATV channel being received (in tune mode) or the selected channel preset (in preset mode).

DTV format indicator LEDs — These three green LEDs light to indicate the digital television format of the input signal. The following resolutions are supported:

SDTV —­ 480i EDTV — 480p

HDTV — 720p and 1080i

When no TV signals are detected, none of these LEDs light.

AVT 200HD Tuner • Operation 13