Extron electronic AVT 200HD BmdX9% ,X5$, EX4@ *X10# *X10$ PB BptX4@ *X5, X7$ = 0, EX7@ CA Ipa

Command	ASCII Command	Response	Additional Description
	(Host to Tuner)	(Tuner to Host)
IP Setup Commands (continued)
View broadcast mode	EEB}	BmdX9%,X5$]
Set broadcast port and MAC	EX4@*X10#*X10$PB}	BptX4@*X5(]	X4@ = UDP outgoing port
address			X10#*X10$ = MAC address for
			UDP unicast transmissions
Set event target IP address	EX7$,X5$ID}	EdiX7$*X5$*X4@]	X7$ = event number (event must
			be running).
			X7$ = 0–99.
Set event target TCP port	EX7$,X4@ID}	EdiX7$*X5$*X4@]
Set event target IP address	EX7$ID}	X5$*X4@]
Password and security settings
Set administrator password24	EX7@CA}	Ipa•X7(]	Set administrator access
			password X7@.
			X7@ = 4 to 12 alphanumeric
			characters. The password is case
			sensitive. Special characters
			(spaces or symbols) are not
			allowed.
			X7( = hidden password, shown
			as four asterisks (****) if a
			password exists; empty if not.
View administrator password24	ECA}	X7(]
Reset (clear) administrator24	E•CA}	Ipa•]	Clear or remove all passwords
password			(administrator and user).
Set user password14,34	EX7@CU}	Ipu•X7(]	Set user access password X7@.
			X7@ = 4 to 12 alphanumeric
			characters. The password is case

sensitive. Special characters (spaces or symbols) are not allowed.

X7( = hidden password, shown as four asterisks (****) if a password exists; empty if not.

NOTE: A user password cannot be assigned if an administrator password does not exist. Entering a password when the AVT has not been configured yields an E14 error response from the tuner. If the administrator password is cleared (removed), the user password is removed also.

View user password	ECU}	X7(]
Reset (clear) user password	E•CU}	Ipu•]	Clear or remove the user
			password.
Query session security level	ECK}	X8*]
		In verbose mode:
		PvlX8*]

Remap Port Destinations

NOTES: • Duplicate port number assignment are pnot permitted (for example, the Telnet and web mapping cannot be the same. An E13 (invalid parameter) error code results.

• Remapping of the port number other than to reset to defaults 80 or 23, or to disable by resetting it to 0 can be done only to ports 1024 or higher.

Set Telnet port map24	EX4@MT}	PmtX4@]	X4@ = Telnet port number
Reset Telnet port map24	E23MT}	Pmt00032]
Disable Telnet port	E0MT}	Pmt00000]
View Telnet port mapping	EMT}	X4@]
		AVT 200HD Tuner • Remote Configuration and Control		62