3.Program the input selection command “A” from the RGB 2 input selection button on the projector remote control into memory block 2 of the MLC 52 PC button:
a.Press the PC button on the MLC front panel. The button blinks, indicating that the MLC is ready to learn the command. On the rear panel, the second LED from the bottom flashes.
b.Within 5 seconds (while the PC button on the MLC 52 is blinking), press the RGB 2 button on the remote control. The MLC learns command “A” for RGB 2.
4.Program the input selection command “B” from the RGB 1 input selection button on the projector remote control into memory block 3 of the MLC 52 PC button:
a.Press the PC button on the MLC front panel. The button blinks, indicating that the MLC is ready to learn the command. On the rear panel, the third LED from the bottom flashes.
b.Within 5 seconds (while the PC button on the MLC 52 is blinking), press the RGB 1 button on the projector remote control. The MLC learns command “B” for RGB 1.
5.Program the input selection command “B” from the RGB 2 input selection button on the projector remote control into memory block 4 of the MLC 52 PC button:
a.Press the PC button on the MLC front panel. The button blinks, indicating that the MLC is ready to learn the command. On the rear panel, the fourth LED from the bottom flashes.
b.Within 5 seconds (while the PC button on the MLC 52 is blinking), press the RGB 2 button on the remote control. The MLC learns command “B” for RGB 2.
6.If finished programming the MLC 52 buttons, return configuration DIP switch 1 to its Off (down) position, and test the system.
If you want to program video input selection at this time, proceed to “Programming video inputs — projector remote control type A.”
Programming video inputs — projector remote control type A
COMPUTER VIDEO
VIDEO AUDIO A/V
MUTE MUTE MUTE
MENUENTER
CONT/ COL/
SIZE CENTER BRT TINT
SHARP | PHASE | ASPECT |
RATIO |
PROJECTOR | |
ON | OFF |
VOL | PC |
| |
VOL | VIDEO |
| |
| MLC 52 |
Command 1: Computer The button should be in input switch mode.
Command 2: Video The button should be in input switch mode.
Projector Remote Control Type B
Figure 37. Programming MLC 52 Input Selection Buttons from a Projector Remote Control Type A
MLC 52 MediaLink Controllers • Special Applications | 40 |
