Configuration for a System with a Projector Remote Control Type B (Application 3)

A type B remote control has only two input buttons: one for the RGB inputs and one for the S-video and composite video inputs (see page 34). Each of these buttons contains two commands (“A” and “B”) that cause the button to toggle between inputs.

Following these steps, use IR learning to program the input selection commands from the projector type B hand-held remote control onto the MLC PC and Video or blank (VC models) buttons.

Programming RGB inputs — projector remote control type B

1.Place the rear panel configuration DIP switch 1 in the On (up) position to enter learning mode.

ON

 

 

 

1

2

3

4

2.Using IR learning, program command “A” from the RGB input selection button on the projector remote control into memory block 1 of the MLC 52 PC button as follows:

a.Press the PC button on the MLC front panel. The button blinks, indicating that the MLC is ready to learn the command. On the rear panel, the bottom IR Learning LED flashes.

b.Within 5 seconds (while the PC button on the MLC 52 is blinking), press the RGB button on the projector remote control. The MLC learns command “A” for RGB.

3.Program the input selection command “B” from the RGB input selection button on the projector remote control into memory block 2 of the MLC 52 PC button as follows:

a.Press the PC button on the MLC front panel. The button blinks, indicating that the MLC is ready to learn the command. On the rear panel, the second LED from the bottom flashes.

b.Within 5 seconds (while the PC button on the MLC 52 is blinking), press the RGB button on the projector remote control. The MLC learns command “B” for RGB.

4.If finished programming the MLC 52 buttons, return configuration DIP switch 1 to its Off (down) position, and test the system.

If you want to program video input selection at this time, proceed to Programming video inputs — projector remote control type B.

Programming video inputs — projector remote control type B

COMPUTER

VIDEO

VIDEO

AUDIO

A/V

MUTE

MUTE

MUTE

MENU

 

ENTER

CONT/ COL/

SIZE CENTER BRT TINT

SHARP

PHASE

ASPECT

RATIO

 

DISPLAY

ON

OFF

VOL

PC

 

VOL

VIDEO

 

Command 1: RGB / IR Command “A”

Command 2: RGB / IR Command “B”

Command 1: Video / IR Command “A”

Command 2: Video / IR Command “B”

MLC 52

Projector Remote Type B

Figure 39. Programming MLC 52 Input Selection Buttons from a Projector Remote Control Type B

MLC 52 MediaLink Controllers • Special Applications

43

Page 49
Image 49
Extron electronic MLC 52 manual Programming RGB inputs projector remote control type B