|
|
|
| INPUTS |
VIDEO | RGB1 | RGB2 | ||
|
|
| ||
SET |
|
|
| POWER |
UP |
| PRG+ |
|
|
|
| PLAY | UP |
|
| TIME/ |
| TIME/ |
|
| LEVEL– DLY/CNT/REAR | LEVEL+ |
| |
| REW | PAUSE | FF |
|
| LEFT |
| RIGHT |
|
STOP DOWN
PRG–
–SKIP/CHAPTER +
TV | DIR A | DECK | DIR |
| |
A/B | B | ||||
INPUT |
|
| |||
|
| +100 |
|
| |
EFFECT | REC/ | SLEEP | TV | ||
PAUSE | |||||
ON/OFF |
|
| MUTE | ||
INPUT SELECT
CD TAPE TUNER
1 2 3
PHONO DVD/LD VCR
4 5 6
TV/DBS
7 8 9
ENT 0 DISP
TEST
|
| DISPLAY |
VOLUME | ON | OFF |
|
| |
Command 1: Video 1 IR Command“A” | VCR | PC |
Command 2: Video 1 IR Command“B” | ||
Command 1: | DVD |
|
Command 2: |
| |
|
| |
|
| MLC 52 |
Command 1: RGB 1 IR Command“A”
Command 2: RGB 1 IR Command“B”
Optional:
Command 1: RGB 2 IR Command“A”
Command 2: RGB 2 IR Command“B” Label the button button accordingly and place it in input switch mode.
Projector Remote Type A |
|
|
|
Figure 38. Programming an MLC 52 VC with a Projector Remote Control Type A | |||
1. Place the rear panel configuration DIP switch 1 in the On (up) position to | ON |
|
|
|
|
| |
enter learning mode. (If the MLC is already in learning mode, proceed to |
|
|
|
step 2.) | 1 | 2 | 3 4 |
2.Using IR learning, program command “A” from the Video input selection button on the projector remote control into memory block 1 of the Video or blank button (for VC models) as follows:
a.Press the Video button on the MLC front panel. The button blinks, indicating that the MLC is ready to learn the command. On the rear panel, the bottom IR learning LED flashes.
b.Within 5 seconds (while the Video button on the MLC 52 is blinking), press the Video or blank button on the projector remote control. The MLC has learned command “A” for video.
3.Program the input selection command “A” from the
a.Press the Video or blank button on the MLC front panel. The button blinks, indicating that the MLC is ready to learn the command. On the rear panel, the second LED from the bottom flashes.
b.Within 5 seconds (while the Video or blank button on the MLC 52 is blinking), press the
4.Program the input selection command “B” from the Video selection button on the projector remote control into memory block 3 of the MLC 52 Video or blank button as follows:
a.Press the Video or blank button on the MLC front panel. The button blinks, indicating that the MLC is ready to learn the command. On the rear panel, the third LED from the bottom flashes.
b.Within 5 seconds (while the Video or blank button on the MLC 52 is blinking), press the Video button on the projector remote control. The MLC learns command “B” for video.
MLC 52 MediaLink Controllers • Special Applications | 41 |
