Serial

Communication

This section describes the procedure for accessing and starting the MLC 52/DVCM 50 Configuration Program and also contains a list and explanations of the Simple Instruction Set (SIS) commands available for the MLC 52. The following topics are covered:

Configuration Ports

Using the MLC 52 Configuration Program

Using SIS Commands

Configuration Ports

The MLC 52 can be remotely configured via a host computer connected to the front panel configuration port (see Front Panel Components on page 28). Through this port, you can program the MLC buttons with commands by using the configuration software (MLC 52/DVCM 50 Configuration Program). You can also issue certain SIS commands through this port.

Using the MLC 52/DVCM 50 Configuration Program

To perform advanced configuration tasks (such as setting button modes, updating firmware, and adding display device drivers), you must use the included MLC 52/DVCM 50 Configuration Program. Many items in the configuration program are also accessible via front panel controls described under Front Panel Features on page 27 (see that section for details on features and settings). Some features are available only via this configuration program. The help file provides information on settings and on how to use the configuration program itself.

To install and run the configuration program, ensure that your computer meets the following system requirements:

Microsoft Windows XP or later

Pentium III or better processor (or compatible)

32 MB free hard disk space

Microsoft Internet Explorer 4.0 or above

4x or higher DVD player

Minimum 1024x768 screen resolution

The configuration software is provided on a DVD, which is packaged with the MLC. The program can also be downloaded at www.extron.com. Install this software on your computer.

MLC 52 MLCMediaLink52 MediaLinkMLCMLCControllers5252MediaLinkControllers• InstallationControllers• SerialandCommunication• I•nfigurationtroducOpera

46

46

Page 52
Image 52
Extron electronic manual Serial Communication, Configuration Ports, Using the MLC 52/DVCM 50 Configuration Program