Frymaster H50 Series manual Replacing an Ignitor Assembly DANGER

5. Reverse the procedure to install the replacement module.

1.6.5 Replacing an Ignitor Assembly

DANGER

Drain the frypot or remove the handle from the drain valve before proceeding further.

1.Disconnect the fryer from the electrical supply.

2.Disconnect the ignition cable from the ignitor by grasping the boot and gently pulling toward you.

3.Remove the sheet metal screw securing the ignitor to the mounting plate and pull the ignitor from the fryer.

4.Reverse the procedure to install the replacement ignitor.

1.6.6 Replacing or Cleaning a Combustion Air Blower

A sheet metal shield or shield assembly prevents inadvertent access to the blower assembly. The specific design varies depending upon the particular configuration of the fryer and the country for which manufactured, but in all cases, the shield is attached to the cabinet framing by sheet metal screws. Remove the screws that secure the shield or shield assembly to the cabinet framing and pull the shield out of the fryer to expose the combustion air blower assembly.

1. Disconnect the blower wiring harness and remove the blower assembly mounting nuts.

Blower

Wiring connection assembly mounting

nuts

2.Remove the three fasteners that secure the blower motor assembly to the blower housing, and separate the two components.

1-10