Frymaster H50 Series manual Reinstall the blower shield or shield assembly

Remove these fasteners. (On black-colored FASCO blowers there are three nuts. On silver-colored KOOLTRONICS blowers there are three screws.)

3.Wrap the motor with plastic wrap to prevent water from entering it. Spray degreaser or detergent on the blower wheel and the blower housing. Allow it to soak for five minutes. Rinse the wheel and housing with hot tap water, then dry with a clean cloth.

Wrap the motor and

wires with plastic wrap

or a plastic bag.

BLOWER HOUSING BLOWER WHEEL

4.Remove the plastic wrap from the blower motor assembly. Reassemble the blower motor assembly and blower housing. Reinstall the blower assembly in the fryer.

5.Reinstall the blower shield or shield assembly.

6.Light the fryer in accordance with the procedure described in Chapter 3, Section 3.1 of the H50 Series Installation and Operation Manual (P/N 819-5000).

7.After the burners have been lit for at least 90 seconds, observe the flames through the burner viewing ports located on each side of the combustion air blower.

1-11