Introduction, Request | Fuji Labs ZSP specification

INTRODUCTION

Congratulations on your purchase of Fuji Gas Analyzer. (Type:ZSP)

•Read this instruction manual carefully to ensure correct installation, operation and maintenance of the gas analyzer. Incorrect handling may lead to unexpected trouble or injury.

•The specifications of the gas analyzer is subject to change without prior notice for improvement.

•Modification of the gas analyzer without permission is strictly prohibited. Fuji is not responsible for any damage caused by modification made without permission.

•This safety precaution/operation manual should be kept by users of the analyzer.

•Keep this manual at hand for your future reference.

•This instruction manual must be given to final users.

Manufacturer	: Fuji Electric Instrumentation Co., Ltd.
Type of product	: Described in nameplate on main frame
Date of manufacture	: See company nameplate on main unit.
Country of manufacture	: Japan

Request

•Transcription of a part or the whole of this manual without permis- sion is prohibited.

•The contents of this manual are subject to change without prior notice.

© Fuji Electric Systems Co., Ltd. 1997

Issued in June, 1997

Rev. 1st edition March, 2000 Rev. 2nd edition January, 2002

– i –

Image 2

Fuji Labs ZSP instruction manual Introduction, Request

Contents

Infrared GAS Analyzer Introduction Request Prohibition Iii Prohibition Others Contents Vii Composition SpecificationsOutline Prepared Selection of gas sampling location InstallationSelection of installation site Installation work Connection of cables Piping procedure Description of Each Part Injection of clean waterSupply of external power Preparation for Operation Warm-up time Setting of temperature inside lockerAirtightness test INDICATION/OPERATION Panel SO2 Function and indication of indication/operation panel This panel consists of the following functions Advice on Operation General operation of indication/operation panel Preparation of standard gas CalibrationKinds of standard gas Pressure regulation for standard gas cylinder Calibration concentration setting except zirconia O2 sensor Func CAL SET ENT CAL Calibration concentration setting zirconia O2 sensor CAL Comp ENT Zero Single-component analyzer Auto calibration Auto CAL Func Auto CAL Func Auto CAL ENT Auto calibration ON/OFF setting Func Hold ENT Operating procedure Operation Maintenance Routine maintenance and inspection Conditioner Centration is measured in the setting range of 0 to Periodic maintenance and inspectionOther maintenance and inspection 200ppm or more at 0.5L/min Maintenance of sampling device Gas extractor type ZBAK1 Membrane filter Exploded view of diaphragm type aspirator Structure of electronic dehumidifier Structure of NO2 /NO converter Structure of Permapure dryer Maintenance of zirconia O2 sensor Others, major component figures Standard Accessories and Spares Standard accessories Spares for 1 year optional Code for preparation of 1-year spares and supplies Processing of Heating Pipe Ends Outline End processing method Grid 300mm 40mm Grid area 150 mm Check after piping Clamp support Specifications of tube trace Specifications of heating pipe Troubleshooting Troubleshooting of instrument Error codes and remedies Power consumption Ambient temperaturePower supply Mass weight Number of output points and kinds of outputs Standard requirements For sample gasMonth/NO2, 100ppm Block diagram Moving average output Calibration tolerance Automatic calibration output hold Automatic calibrationOrdering information Calibration cycle Once/day variable, up to 7 days Code Symbols Diaglam Functions of individual components For outdoor installation type For indoor installation type Connection Diagram Only specified outputs are wired Head Office Instrumentation Div International Sales Dept