Automatic calibration, Ordering information | Fuji Labs ZSP instruction

Automatic calibration

•Calibration tolerance:

•Automatic calibration output hold:

±0.2% FS Possible

(Example in 4 component analyzer):

CO zero

CO span

O2 zero

NOx, SO2 zero

NOx span

SO2 span

O2 span

Automatic calibration

• Calibration cycle:

Once/day (variable, up to 7 days)

•Calibration gas feed time:2 to 10 min. (variable), common to each gas

• Display:	Calibration failure
	Error code (E-) is displayed when one-time calibration volume is more
	than ± 20% FS on both zero and span and it is under calibration:

	CAL	lamp ON

Ordering information

1.Measuring range of analyzer

2.Length of sampling pipe

3.Insertion length of sampling tube

4.Power voltage/frequency

5.Instruction required when standard gas is not necessary

6.Instruction required when individual inspection is not necessary

7.Necessity of spares and supplies (for 1 year)

8.Additional functions

Note: When special functions such as remote range selection, output hold by external contact, auto- matic calibration, automatic calibration start by external contact, insulation output, measured value concentration alarm, etc. are required, they should be separately designated.

– 48 –

Image 56

Fuji Labs ZSP instruction manual Ordering information, Calibration tolerance Automatic calibration output hold, Display

Contents

Infrared GAS Analyzer Introduction Request Prohibition Iii Prohibition Others Contents Vii Specifications OutlineComposition Prepared Selection of gas sampling location InstallationSelection of installation site Installation work Connection of cables Piping procedure Injection of clean water Supply of external powerDescription of Each Part Preparation for Operation Warm-up time Setting of temperature inside lockerAirtightness test INDICATION/OPERATION Panel SO2 Function and indication of indication/operation panel This panel consists of the following functions Advice on Operation General operation of indication/operation panel Preparation of standard gas CalibrationKinds of standard gas Pressure regulation for standard gas cylinder Calibration concentration setting except zirconia O2 sensor Func CAL SET ENT CAL Calibration concentration setting zirconia O2 sensor CAL Comp ENT Zero Single-component analyzer Auto calibration Auto CAL Func Auto CAL Func Auto CAL ENT Auto calibration ON/OFF setting Func Hold ENT Operating procedure Operation Maintenance Routine maintenance and inspection Conditioner Periodic maintenance and inspection Other maintenance and inspectionCentration is measured in the setting range of 0 to 200ppm or more at 0.5L/min Maintenance of sampling device Gas extractor type ZBAK1 Membrane filter Exploded view of diaphragm type aspirator Structure of electronic dehumidifier Structure of NO2 /NO converter Structure of Permapure dryer Maintenance of zirconia O2 sensor Others, major component figures Standard Accessories and Spares Standard accessories Spares for 1 year optional Code for preparation of 1-year spares and supplies Processing of Heating Pipe Ends Outline End processing method Grid 300mm 40mm Grid area 150 mm Check after piping Clamp support Specifications of tube trace Specifications of heating pipe Troubleshooting Troubleshooting of instrument Error codes and remedies Ambient temperature Power supplyPower consumption Mass weight Number of output points and kinds of outputs Standard requirements For sample gasMonth/NO2, 100ppm Block diagram Moving average output Automatic calibration Ordering informationCalibration tolerance Automatic calibration output hold Calibration cycle Once/day variable, up to 7 days Code Symbols Diaglam Functions of individual components For outdoor installation type For indoor installation type Connection Diagram Only specified outputs are wired Head Office Instrumentation Div International Sales Dept