12.3 Check after piping

qThe heating pipe is not sunk significantly due to a clamp, etc.

wThe bent section has an adequately large bending radius.

eElectrical connections are exact.

rThe end of heater wire (bus) is not short-circuited (it must never be short-circuited).

tAll parts of the connection kit (sealing connector), etc. have been used.

yScrews of the connection kit (sealing connector), etc. have been tightened completely.

12.4Clamp support

Clamps for conduit should be used. For heating pipe profile of the tube trace, refer to 12.5. The heating pipe should be clamped so that it will be sunk significantly.

No good

Good

Fig. 12-8

– 41 –

Page 49
Image 49
Fuji Labs ZSP instruction manual Check after piping, Clamp support