CLI |
| Command Reference |
7.2CLI Mode-based Topology
Parameters
Parameters are order dependent.
The text in bold italics should be replaced with a name or number. To use spaces as part of a name parameter, enclose it in double quotes like this: "System Name with Spaces".
Parameters may be mandatory values, optional values, choices, or a combination.
–<parameter>. The <> angle brackets indicate that a mandatory parameter must be entered in place of the brackets and text inside them.
–[parameter]. The [] square brackets indicate that an optional parameter may be entered in place of the brackets and text inside them.
–choice1 choice2. The indicates that only one of the parameters should be entered. The {} curly braces indicate that a parameter must be chosen from the list of choices.
Values
ipaddr This parameter is a valid IP address, made up of four decimal bytes ranging from 0 to
255.The default for all IP parameters consists of zeros (that is, 0.0.0.0). The interface IP address of 0.0.0.0 is invalid.
macaddr The MAC address format is six hexadecimal numbers separated by colons, for example 00:06:29:32:81:40.
slot/port This parameter denotes a valid slot number, and a valid port number. For example, 0/1 represents slot number 0 and port number 1. The <slot/port> field is composed of a valid slot number and a valid port number separated by a forward slash (/).
logical slot/port This parameter denotes logical slot number, and logical port number assigned. This is applicable in the case of a
Conventions
Network addresses are used to define a link to a remote host, workstation, or network. Network addresses are shown using the following syntax:
Table 5-1. Network Address Syntax
Address Type | Format | Range |
|
|
|
IPAddr | A.B.C.D | 0.0.0.0 to 255.255.255.255 |
|
|
|
124 | Intelligent Blade Panel Module |
