Figure Legend

4Locator LED Button

5USB Port 2

6USB Port 3

▼To Connect the Service Processor Serial Management Port

The service processor serial management port is marked SER MGT (FIGURE 2-18). It is the leftmost RJ-45 port on the rear panel.

Note – The cable and DB-9 RJ-45 adapters are for the host serial port, and not for the server SER MGT port.

FIGURE 2-18Service Processor Serial Management Port – Rear Panel

Use this port for server management. This port is needed to set up the service processor network management port, as detailed in “Enabling the Service Processor Network Management Port” on page 46.

Note – Use the service processor serial management port only for server management. It is the default connection between the service processor and a terminal or a computer.

Caution – Do not attach a modem to this port.

●Connect a Category 5 cable from the SER MGT serial management port to the terminal device.

When connecting either a DB-9 or a DB-25 cable, use an adapter to perform the crossovers given for each connector.

Chapter 2 Installing the SPARC Enterprise T5120 and T5220 Servers 35