Note – To see these status and error messages, connect a terminal or terminal emulator to the serial management port (SERIAL MGT). For a basic procedure to connect a terminal or terminal emulator, see “To Power On the System for the First Time” on page 43.
For a more detailed discussion on configuring the system console and connecting terminals, refer to the SPARC Enterprise T5120 and T5220 Server Administration Guide.
ILOM Service Processor
After the system console finishes its
By default, the network management port is configured to automatically retrieve network configuration using Dynamic Host Configuration Protocol (DHCP) and to allow connections using Secure Shell (SSH).
Note – If you are unable to use DHCP and SSH on your network, you must connect to the ILOM service processor using the serial management port to reconfigure the network management port. See “To Configure the Service Processor Network Management Port” on page 48.
Once the network management port (NET MGT) has been assigned an IP address, you can connect to the ILOM service processor using SSH.
CLIs, User Accounts, and Passwords for Connecting to the ILOM Service Processor
When connecting to the ILOM service processor for the first time using the serial or network management ports, the default CLI is ILOM, the default user account is root, and the default password is changeme. Examples in this document use the default ILOM CLI.
ILOM also provides an Advanced Lights Out Management (ALOM) compatability CLI that uses commands that resemble the ALOM CMT CLI commands. To access the ALOM compatability CLI, you must first create an admin account with the role of administrator. Once you create the admin account, assign the ALOM
42 SPARC Enterprise T5120 and T5220 Servers Installation Guide • August 2007