A P P E N D I X C

Installing the Servers With the

Express Rail Rackmounting Kit

This appendix provides instructions for installing the servers in an equipment rack with Express (snap-in) rails. The Express rail rackmounting kit installs quickly and does not require mounting screws or nuts. The kit and the installation procedures are the same for both the SPARC Enterprise T5120 and T5220 servers.

Note – If your rackmount kit came with its own instructions, use the instructions in your rackmount kit instead of the instructions in this appendix. After performing the server installation, proceed to Chapter 3 for first-time power on.

Note – The procedures in this appendix are the same for both the 1U and 2U servers. The illustrations show a 2U server only as an example.

This chapter contains the following sections:

■“Installing the Servers in a Rack With Express Rails” on page 71

■“Installing the Cable Management Arm” on page 79

■“Connecting the Server Cables” on page 79

■“Managing Cables With the CMA” on page 79

■“Dismounting the Server” on page 79

Note – References to left and right are from your viewpoint as you face either the front or the rear of the system.

67