5.If you choose to use a static IP configuration, set the parameters pendingipdiscovery, pendingipaddress, pendingipgateway, and pendingipnetmask as follows.

a. Set the service processor to accept a static IP address.

-> set /SP/network pendingipdiscovery=static

Set 'pendingipdiscovery' to 'static'

b. Set the IP address for the service processor.

-> set /SP/network pendingipaddress=service-processor-IPaddr

Set 'pendingipaddress' to 'service-processor-IPaddr'

c. Set the IP address for the service processor gateway.

-> set /SP/network pendingipgateway=gateway-IPaddr

Set 'pendingipgateway' to 'gateway-IPaddr'

d. Set the netmask for the service processor.

-> set /SP/network pendingipnetmask=255.255.255.0

Set 'pendingipnetmask' to '255.255.255.0'

This example uses 255.255.255.0 to set the netmask. Your network environment subnet might require a different netmask. Use a netmask number most appropriate to your environment.

6.Use the show /SP/network command to verify that the parameters were set correctly.

CODE EXAMPLE 3-2 show /SP/network Command Output

-> show /SP/network

/SP/network

Targets:

Properties:

commitpending = (Cannot show property) dhcp_server_ip = xx.x.xx.x

ipaddress = xx.x.xx.x ipdiscovery = dhcp ipgateway = xx.x.xx.x ipnetmask = 255.255.252.0 macaddress = 00:14:4F:3F:8C:AF pendingipaddress = xx.x.xx.x

50 SPARC Enterprise T5120 and T5220 Servers Installation Guide • August 2007