CODE EXAMPLE 3-2 show /SP/network Command Output

pendingipdiscovery = static pendingipgateway = xx.x.xx.x pendingipnetmask = 255.255.255.0 state = enabled

Commands: cd set show

->

Note – After setting the configuration parameters, you must enter the set /SP/network commitpending=true command for the new values to take affect.

7. Commit the changes to the service processor network parameters.

-> set /SP/network commitpending=true

Set 'commitpending' to 'true'

▼To Reset the Service Processor

It is not necessary to reset the service processor for new network values to take affect. To commit the changes to the service processor network parameters, use the set /SP/network commitpending=true command. See Step 7 in “To Configure the Service Processor Network Management Port” on page 48.

●Type the reset /SP command.

You are prompted to confirm that you want to reset the service processor. Reply y when prompted.

-> reset /SP

Are you sure you want to reset /SP (y/n)? y

Note – You can specify the -scriptoption to bypass the confirmation question, for example, reset -script /SP.

Chapter 3 Powering On the System 51