■/SP/network pendingipgateway – IP address of the gateway for the subnet

■/SP/network pendingipnetmask – Netmask for the service processor subnet

■/SP/network pindingipdiscovery - Specifies whether the service processor uses DHCP or static IP address assignment

■/SP/network commitpending - Commits the service processor to use the pending settings

Configure these parameters with the set command. The usage is as follows: set target property=value where /SP/network is the target and pendingipaddress=xx.x.xx.xxx, for example, is the property=value. The following example sets the pending service processor IP address:

-> set /SP/network pendingipaddress=xx.x.xx.xxx

Set 'pendingipaddress' to 'xx.x.xx.xxx'

1.Set the /SP/network state parameter to enabled.

-> set /SP/network state=enabled

Set 'state' to 'enabled'

2. Enable and disable SSH connections as needed.

-> set /SP/services/ssh state=enabled

Set 'state' to 'enabled'

-> set /SP/services/ssh state=disabled

Set 'state' to 'disabled'

See the Integrated Lights Out Manager 2.0 Supplement for SPARC Enterprise T5120 and T5220 Servers for more information about SSH support in ILOM.

3.Choose one of these methods to configure the service processor using information from your network administrator:

■Use DHCP to retrieve the network settings. Go to Step 4.

■Configure a static IP configuration. Go to Step 5.

4. If you choose to use DHCP, set pendingipdiscovery to dhcp.

-> set /SP/network pendingipdiscovery=dhcp

Set 'pendingipdiscovery' to 'dhcp'

Go to Step 6.

Chapter 3 Powering On the System 49