The service processor network management port is not operational until you configure network settings for the service processor. Configure the service processor in this order:
1.After the service processor boots, access the ILOM CLI through the serial management port. See “To Log Into the Service Processor Using the Serial Management Port” on page 47.
2.Configure the service processor. See “To Configure the Service Processor Network Management Port” on page 48.
3.Commit the changes to the service processor parameters. See Step 7 in “To Power On the System for the First Time” on page 43.
You can now use the network management port at any time to access the service processor. See “To Log Into the Service Processor Using the Network Management Port” on page 52.
Logging Into the Service ProcessorIf you are powering on the system for the first time after installation, use the service processor serial port to power on the system and run POST. See “To Log Into the Service Processor Using the Serial Management Port” on page 47.
If the network management port has already been configured, you can use it instead of the serial management port. See “To Log Into the Service Processor Using the Network Management Port” on page 52.
46 SPARC Enterprise T5120 and T5220 Servers Installation Guide • August 2007