▼To Connect the Service Processor Network Management Port

The service processor network management port is labeled NET MGT (FIGURE 2-19). It is located just to the right of the serial management (SER MGT) port on the rear panel.

FIGURE 2-19Service Processor Network Management Port – Rear Panel

Note – This port is not operational until you configure the network settings (through the serial managment port), as detailed in “To Configure the Service Processor Network Management Port” on page 48.

Note – If you have access to a DHCP server on the network, you can see the service processor get an IP address because the DHCP client is enabled by default.

Note – The service processor network management port is configured by default to retrieve network settings with Dynamic Host Configuration Protocol (DHCP) and allow connections using Solaris Secure Shell (SSH). You might need to modify these settings for your network. Instructions are given in Chapter 3.

●Connect a Category 5 cable from the NET MGT network management port to your network switch or hub.

▼To Connect the Ethernet Network Cables

The server has four network connectors, marked NET0, NET1, NET2, and NET3 (FIGURE 2-20). These connectors are RJ-45 Gigabit Ethernet.

36 SPARC Enterprise T5120 and T5220 Servers Installation Guide • August 2007