▼To Connect the AC Power Cable to the Server

Powering on the system for the first time requires special preparation and procedures. For example, if you have not prepared a display before connecting the AC power cable, system messages might be lost.

Caution – Finish the hardware procedures in this chapter, but do not attach the AC power cable yet.

Powering on the system for the first time requires special preparation and procedures. For example, if you have not prepared a display before connecting the AC power cable, system messages could be lost.

Caution – The server goes into Standby mode and the service processor initializes as soon as the AC power cable is connected to the power source.

●Go to “Powering On the System for the First Time” on page 41 for instructions on connecting the server to AC power.

Managing Cables With the CMA

Managing the cables with the CMA is the same for both servers.

▼Securing the Server Cables in the CMA

●Once the server cables are connected and placed inside the CMA, open the velcro cable straps and wrap the straps around the CMA securing the cables inside the CMA. (FIGURE 2-21).

38 SPARC Enterprise T5120 and T5220 Servers Installation Guide • August 2007