Gateway 312785C important safety instructions Connect the Module to EasyKey, Cabling Connections

Install the Gateway Module Hardware

Connect the Module to the

EasyKey

FIG. 1 is only a guide showing installation of the Graco Gateway in a ProMix 2KS System; it is not a complete system design, Contact your Graco distributor for assis- tance in designing a system to suit your particular needs.

1.Shut off ProMix 2KS power (0 position). FIG. 2. Also shut off power at main circuit breaker.

0 = OFF

TI12657a

FIG. 2: Power Off

2.Connect a 2-wire twisted pair cable with shield wire from the EasyKey connector to the connector on the Gateway module. Connect a communications wire/cable (protocol dependent) from the Gateway module to the PLC. See FIG. 3.

NOTE: Graco provides expansion cards for DeviceNet and Profibus protocols. DeviceNet setup procedures are on page 42. Profibus setup procedures are on page 57. See page 40 for Parts.

NOTE: If using the Graco Gateway in your system, dis- connect its cable from the EasyKey before updating the ProMix 2KS software.

Cabling Connections

See FIG. 4 and FIG. 5 for typical cable connections in a

ProMix 2KS system.

FIG. 6 through FIG. 9 show other possible cable connec- tions.

312785C 7