e.In the Name field, enter a descriptive name to identify the module. See FIG. 72.
f.In the Address/Host Name field, enter the IP Address of the Graco Gateway.
g.Enter 2 in the Input Assembly Connection Point and a size of 2. This will match a read only Slave Gateway block configured in the Gateway, and will be used for reading data from the Gate- way to the ControlLogix.
h.Enter 3 in the Output Assembly Connection Point and a size of 2. This will match a read/write Slave Gateway block configured in the Gateway, and will be used for writing data from the ControlLogix to the Gateway.
Appendix C: Graco Gateway to ControlLogix via Ethernet IP
i.Enter 1 in the Configuration Connection Point and a size of 0. Configuration data is not sup- ported by the Gateway.
j.Press Finish to add the Gateway to the I/O con- figuration.
The connection points and sizes are arbitrary, as long as the connection point, size, and direction are matched in the configuration of the Gateway.
Connection point direction is always relative to the originator, which in the case of the current Gateway Ethernet/IP implementation is always the device and never the Gateway. An input connection therefore specifies data flow from the Gateway to the device, and an output connection specifies data flow from the device to the Gateway.
FIG. 72. Ethernet Module Properties
312785C | 75 |
