GE Energy Services
68K System Monitor
User's Guide
SWM0023 1.00 2 General
3-40 Full Release
HT - HDLC Test
Platform oCPM þD20
D20 Base þD20 ME
D20 Base oD20/200
CCU Base þD20/200 ME
CCU Base oD25
Description Use this command to transmit specific application messages over the HDLC
communication link.
Note: Because you must assemble these messages by hand, you can not use the
command effectively unless you know the protocol used by the D.20
application.
Syntax Below is usage and syntax information for this command
Command Format ht /(c | m | r | s | w)
Variables /c = configure the link parameters
/m = define the application message
/r = read (monitor) the link
/s = display configuration status
/w = send an application message
Parameters None
Example None required
Special
Considerations
This command is not available on the CPM.
This command is not available if the D.20 (B003) application
is active.