| 68K System Monitor |
GE Energy Services | User's Guide |
|
|
ERASE - Flash Erase
Platform
Description
o CPM | o D20 | þ D20 ME | o D20/200 | þ D20/200 ME | þ D25 |
| D20 Base | D20 Base | CCU Base | CCU Base |
|
|
| ||||
Note: | this command is available only when executing from the BootROM. This | ||||
| will be indicated by the D25A>, or the D20MEA> prompts for the D25 or | ||||
|
|
| |||
Use this command to perform an erase of the Flash memory region, resetting all bytes in Flash to 0xFF in preparation for application data download.
Syntax
!
WARNING
Below is usage and syntax information for this command
Command Format | D25: |
| erase [/d /y] |
| D20 ME / CCUME: | erase [/y] | |
|
|
|
|
Variables | None |
|
|
|
|
|
|
Parameters | /d | = erase DSP Flash |
|
| /y | = disable the verification prompts | |
|
|
| |
Example | Type erase and press ENTER. |
| |
| Results: If you confirm the erase prompt, the command erases | ||
|
| the Flash EPROM. |
|
|
| ||
Special | The command prompt will return if Flash is already clear when | ||
Considerations | the erase command is invoked. Otherwise, the command | ||
| prompts the user to confirm the Flash erase. | ||
| If you enter any response other than “y”, the command aborts | ||
| the erase. |
|
|
|
|
|
|
Executing this command modifies RTU memory and will cause operational disruption (specifically by destroying all Flash application code).
Do not use this command unless you are prepared to perform a code download procedure.
Use caution before proceeding.
SWM0023 1.00 2 | General |
Full Release | |
|
