GE 68K System manual Error Messages

68K System Monitor

User's Guide GE Energy Services

Error Messages

Introduction	68K Monitor returns several general error messages resulting from input or syntax
	errors in the command input, or system or test failures during execution.
	These error messages are identified below:
Message	The most general error is an incorrect number of arguments for the command
Summary	defined. This error causes a display of the correct use of the specified function.
	Other possible error messages are listed below:
	This Message	is displayed when…
	Application which	a process or user requests an exit command, but the
	activated the monitor	process that called 68K Monitor is suspended or
	has been deleted! (or	deleted.
	suspended)
	Breakpoint defined!	the specified address is already defined as a breakpoint,
		the monitor will display this message when defining a
		new breakpoint (DB).
	Breakpoint not	a breakpoint was not encountered when attempting a
	suspended!	resume (RB) or step (SB) breakpoint command.
	Cannot post to	a send (SX) or jam (JX) exchange command encounters
	exchange!	an error in sending the message to the specified
		exchange.
	Command aborted!	the user replied NO when asked to verify a Return to
		BootROM (RTB) command.
	Command not found!	the specified command is not located within 68K
		Monitor’s command list.
	FLASH invalid!	a directory (DIR) command on a FLASH default
		database fails (i.e., no default database could be
		detected).
	Invalid ID!	the monitor cannot find the specified identification, or it
		is incorrect. The ID can be a breakpoint number,
		communications port, table name, or process or
		exchange ID
	Invalid switch!	the user does not specify the mode for the chosen
		function.
	No free breakpoints!	the define breakpoint (DB) command is attempted when
		all available breakpoints are in use.
	Numeric input error!	a numeric field contains non-numeric characters.
		Continued on next page
General		SWM0023-1.00 -2

Full Release 1-7