GE EPM 5350 Access Modes, Print Operating Data, Step, Phase/Next, b. Press PHASE/ NEXT to

CHAPTER 5: OVERVIEW

5.10: Access Modes

The following access commands allow the user to perform specific operations.

ACCESS	OPERATION
COMMANDS
1	Print Operating Data
2	Print Programming Data
3	Enter Programming Mode (see Programming Section)
4	Firmware Version/LED Test

Note: Print commands 1 and 2 are only available if enabled in the programming mode; they are not recommended when using the multimeter connection RS-485.

5.11 Print Operating Data

This function sends data to a serial printer, creating a hard copy of the instantaneous and max/min data of all functions and the WH, VAH, and WH counters.

Note: This function applies only if a serial printer is connected to the EPM 5300P via an RS-232C Communication Converter.

To print the operating data:

MAX	AC VOLTS
	A B C A B	C
MIN
	N N N B C A
LM1
LM2	AC AMPS
	A B C N
	POWER

PF

KW

KVA

KVAH KWH FREQ KVAR

MAX	AC VOLTS
	A	B C A B	C
MIN
	N N N B C A
LM1
LM2	AC AMPS
		A B C N
		POWER

			PF
			KW
			KVA
KVAH	KWH	FREQ	KVAR

MAX	AC VOLTS
	A B C A B C
MIN	N N N B C A
LM1
LM2	AC AMPS
	A B C N
	POWER

			PF
			KW
			KVA
KVAH	KWH	FREQ	KVAR

MAX/MIN	VOLTS	AMPS	POWER	PHASE	MAX/MIN			POWER	PHASE
LIMITS				NEXT		VOLTS	AMPS
					LIMITS				NEXT

Step 1:	Step 2:
a. Press and hold	a. Press AMPS until a 1
	appears..
PHASE/NEXT.	b. Press PHASE/ NEXT to
b. Press AMPS until a 0
appears in the middle	select.
display.

c.Release both buttons.

MAX/MIN	VOLTS	AMPS	POWER	PHASE
LIMITS					NEXT

!111 appears, confirming a successful print command.

34 EPM 5000 series Advanced Power Meters GE Multilin