GE EPM 5350, EPM 5200, EPM 5300 instruction manual Group 0, Function 3-System Configuration, Pack

CHAPTER 9: PROGRAMMING GROUP 0 – GLOBAL METER SETUP

MAX	AC VOLTS
	A B C A B C
MIN	N N N B C A
LM1
LM2	AC AMPS
	A B C N
	POWER

PF

KW

KVA

KVAH KWH FREQ KVAR

MAX/MIN	VOLTS	AMPS	POWER	PHASE
LIMITS				NEXT

Step 3:

a. Press AMPS to begin Data Entry Sequence.

!The previous value shifts to middle display and four dashes appear in lower display.

b. Press VOLTS for desired number.

c. Press AMPS to store each digit.

MAX	AC VOLTS
	A B C A B C
MIN	N N N B C A
LM1
LM2	AC AMPS
	A B C N
	POWER

PF

KW

KVA

KVAH KWH FREQ KVAR

MAX/MIN	VOLTS	AMPS	POWER	PHASE
LIMITS				NEXT

!Repeat this procedure until new Communication Baud Rate is entered.

!When complete, middle display blanks and lower display indicates new Baud Rate.

See Chapter 14 to Exit.

9.4: Group 0, Function 3—System Configuration

The System Configuration sets the EPM 5300P’s basic operational parameters. This Function utilizes Switch PACKS.

FUNCTION 3 contains four different Switch PACKS: 0–3. Each PACK contains four individual UP/DOWN segments.

•Toggling the segment between UP and DOWN, toggles the switch ON or OFF, or chooses between two options.

•The meter displays one Switch PACK at a time.

!Press VOLTS to scroll from PACK to PACK.

	GROUP
			FUNCTION
				PACK
M AX				AC VOLTS
				A	B C A	B	C
M IN				N	N N B	C	A
LM 1
LM 2				AC AMPS				PREVIOUS
					A B C N
					POWER			SETTING
					PF			NEW
					KW
KVAH	KW H			FREQ	KVA			SETTING
					KVAR
MAX/MIN	VOLT		AM P	POW ER	PHASE
LIM IT			S		NEXT
SW ITCHES: A		B	C	D

46 EPM 5000 series Advanced Power Meters GE Multilin