GE EPM 5200, EPM 5300, EPM 5350 instruction manual To change the scale factor setting for wattage

CHAPTER 10: PROGRAMMING GROUP 1

To change the scale factor setting for wattage:

NOTE: Press MAX/MIN/LIMITS at any time to cancel before storing the last digit or switch.

MAX	AC VOLTS
	A B C A B C
MIN	N N N B C A
LM1
LM2	AC AMPS
	A B C N
	POWER

				PF
				KW
				KVA
KVAH	KWH		FREQ	KVAR
MAX/MIN	VOLTS	AMPS	POWER	PHASE
LIMITS				NEXT

Step 1:

a. Enter Group Level of Programming Mode (see Chp. 8).

b. Press MAX/MIN/LIMITS until 1. appears in upper display.

MAX	AC VOLTS
	A B C A B C
MIN	N N N B C A
LM1
LM2	AC AMPS
	A B C N
	POWER

PF

KW

			KVA
KVAH	KWH	FREQ
			KVAR

MAX/MIN	VOLTS	AMPS	POWER	PHASE
LIMITS				NEXT

Step 2:

a. Press AMPS to activate the Group.

b. Press MAX/MIN/LIMITS until 12. appears in upper display.

!Middle display indicates current Scale Factor Setting.

!Lower display indicates 9999 (including current decimal placement).

MAX	AC VOLTS
	A B C A B	C
MIN
	N N N B C A
LM1
LM2	AC AMPS
	A B C N
	POWER

PF

KW

KVAH	KWH	FREQ	KVA
			KVAR

MAX/MIN	VOLTS	AMPS	PHASE
LIMITS			POWER
			NEXT

ENTERING THE SCALE FACTOR:

Step 3:

a. Press AMPS to begin Data Entry Sequence.

!Lower display is replaced with a single dash.

b. Press VOLTS to move the segment

!UP signifies - megawatts.

!DOWN signifies - kilowatts..

c. Press AMPS to store.

MAX	AC VOLTS
	A B C A B	C
MIN
	N N N B C A
LM1
LM2	AC AMPS
	A B C N
	POWER

PF

KW

KVAH	KWH	FREQ	KVA
			KVAR

MAX/MIN	VOLTS	AMPS	PHASE
LIMITS			POWER
			NEXT

DECIMAL POINT SELECTION:

Step 4:

!Display blanks and 9999 appears in lower display (including current decimal setting).

a. Press VOLTS to move decimal.

b. Press AMPS to store.

See Chapter 14 to Exit.

GE Multilin EPM 5000 series Advanced Power Meters 65