GE EPM 5200, EPM 5300, EPM 5350 instruction manual Configuration Parameters, Baud Rate

CHAPTER 16: ETHERNET OPTION

16.7: Configuration Parameters

After entering Setup Mode (confirm by pressing Enter), you an configure the parameters by entering one of the numbers on the Change Setup Menu, or you can confirm default values by pressing Enter. Be sure to store new configurations when you are finished. The Ethernet Interface will then perform a power reset.

Serial Number 5415404 MAC Address 00:20:4A:54:3C:2C

Software Version V01.2 (000719)

Press Enter to go into Setup Mode

1)	Network/IP Settings:
	Ethernet Interface Autodetect
	IP Address	- 0.0.0.0/DHCP (Customer Configurable)
	Default Gateway	--- not set	---	(Customer Configurable)
	Netmask	--- not set	---	(Customer Configurable)
2)	Serial & Mode Settings:
	Protocol	Modbus/RTU, Slave(s) attached (FIXED)
	Serial Interface	9600,8,N,1,RS232,DB25 (must match meter) (FIXED)
3)	Modem Control Settings:
	DCD Output	Fixed High/Active
	CTS Output	Fixed High Active
4)	Advanced Modbus Protocol Settings:
	Slave Addr/Unit Id Source	Modbus/TCP header (FIXED)
	Modbus Serial Broadcasts	Disabled
	Character, Message Timeout	00010 ms, 00500 ms

D)default settings, S) save, Q) quit without save;

select command or parameter set (1..4) to change: I

BAUD RATE

The Ethernet Interface and attached serial device (the meter) must agree on a speed or baud rate used for the serial connection. Valid baud rates are 1200, 2400, 4800 and 9600 (default). For the EPM 5350P, default settings are 9600 baud rate, 8 data, 1 stop, no parity, Modbus RTU.

GE Multilin EPM 5000 series Advanced Power Meters 95