GE EPM 5300, EPM 5200, EPM 5350 instruction manual Ethernet Module

ETHERNET MODULE CHAPTER 16: ETHERNET OPTION

16.1 Ethernet Module

The Ethernet connection is made with a small module added to the back of the meter. This small but powerful module has simply an RJ-45 Port and four Status LEDs.

ETHERNET 10 BASE T RJ-45

MOD.#

SER.#

LK

DG

	LED DETAIL
GREEN 1		4 GREEN
RED 3		2 YELLOW

See the Table below for a description of the Status LED functions.

LED	Description	LED Functions
	Serial Port	Lights solid green to indicate Channel 1 is IDLE.
1	(Channel) 1	Blinks green to indicate Channel 1 is connected to
	Status	the network and ACTIVE.
	Serial Port	Lights solid yellow to indicate Channel 2 is IDLE.
		Blinks yellow to indicate Channel 2 is connected to
2	(Channel) 2
		the network and ACTIVE.
	Status
		(Not used by this device; reserved for future use)
		Blinks or lights solid red in combination with the
		green (Channel 1) LED to indicate DIAGNOSTICS and
		ERROR DETECTION.
		Red solid, green (Channel 1) blinking:
		1x: EPROM checksum error
		2x: RAM error
3	Diagnostics	3x: Network controller error
		4x: EEPROM checksum error
		5x: Duplicated IP address on network*
		6x: Software does not match hardware*
		Red blinking, green (Channel 1) blinking:
		4x: Faulty network connection*
		5x: No DCHP response received*
4	Network Link	Lights solid green to indicate network port is
	Status	connected to the network.

* Non-fatal error

16–118 EPM 5300 SERIES ADVANCED POWER METERS – INSTRUCTION MANUAL