GE EPM 5350, EPM 5200, EPM 5300 instruction manual Group 0, Function 2 Baud Rate

GROUP 0, FUNCTION 2 — BAUD RATE CHAPTER 9: PROGRAMMING GROUP 0 - GLOBAL METER SETUP

9.2Group 0, Function 2 — Baud Rate

BAUD RATE: Speed at which data is transmitted between meter and remote computer or serial printer. The rate programmed into the meter must match the rate used by the remote device. Valid Baud Rates are 1200, 2400, 4800 and 9600.

To change the Baud Rate:

Press MAX/MIN/LIMITS at any time to cancel before storing the last digit or switch.

MAX			AC VOLTS
			A B C A B C
MIN			N N N B C A
LM1
LM2			AC AMPS
				A B C N
				POWER
				PF
				KW
				KVA
KVAH	KWH		FREQ	KVAR
MAX/MIN	VOLTS	AMPS	POWER	PHASE
LIMITS				NEXT

Step 1:

a. Enter Group Level of Programming Mode (see Chp. 8). b. Press MAX/MIN/LIMITS until 0. appears.

c. Press AMPS to activate the Group.

MAX	AC VOLTS
	A B C A B	C
MIN
	N N N B C A
LM1
LM2	AC AMPS
	A B C N
	POWER

			PF
			KW
			KVA
KVAH	KWH	FREQ	KVAR
MAX/MIN	VOLTS AMPS	POWER	PHASE
LIMITS			NEXT

Step 2:

a. Press MAX/MIN/LIMITS until Function 02. appears in upper display.

Lower display indicates current Baud Rate.

MAX	AC VOLTS
	A B C A B C
MIN	N N N B C A
LM1
LM2	AC AMPS
	A B C N
	POWER

			PF
			KW
			KVA
KVAH	KWH	FREQ	KVAR
MAX/MIN	VOLTS AMPS	POWER	PHASE
LIMITS			NEXT

Step 3:

a. Press AMPS to begin Data Entry Sequence.

The previous value shifts to middle display and four dashes appear in lower display.

b. Press VOLTS for desired number.

c. Press AMPS to store each digit.

MAX	AC VOLTS
	A B C A B	C
MIN
	N N N B C A
LM1
LM2	AC AMPS
	A B C N
	POWER

			PF
			KW
			KVA
KVAH	KWH	FREQ	KVAR
MAX/MIN	VOLTS AMPS	POWER	PHASE
LIMITS			NEXT

Repeat this procedure until new Communication Baud Rate is entered.

When complete, middle display blanks and lower display indicates new Baud Rate.

See Chapter 14 to Exit.

9–56 EPM 5300 SERIES ADVANCED POWER METERS – INSTRUCTION MANUAL