GE GFK-0787B user manual Analog I/O Group Configuration

6

Analog I/O Group Configuration

Select Analog to configure any analog group. Select a triplex, duplex, or simplex analog input group, then select the block type (6 inputs or 4 inputs/2 outputs). For example:

'

Note: Aªsimplexº input group has just one I/O block, installed on one bus, but configured as a GMR block. It is not the same a ªnon-votedº block. To configure a GMR group with just one analog block, select Simplex Analog from the menu of analog group types as described above.

ID	Enter a name or a description of up to 12 characters, such as
	ªin group 6º. This entry is for your information only. It is not used by
	the GMR software.

Start %AI The voted analog references start at %AI0001. The size of the voted analog input area is determined by the number of voted analog inputs including spares. Within this area, enter the starting %AI Input Table reference for the block. This will be the %AI address of the voted input data. The actual %AI references used for the ªrawº input data from the block (shown as A inputs, B inputs, C inputs in the diagram below) are configured using the Logicmaster 90 software. The GMR configuration software will provide a printout of the addressing required for Logicmaster 90. The allowable reference range is 1 to 1024.

Input

Voting

Logic

Ainputs

Binputs

Cinputs

%AI0001

A

B

C

Voted Inputs

non-voted Inputs

Duplicate addresses are not allowed within a GBC group. You will not be permitted to continue until you have entered a unique address.

	SBA	Enter a serial bus address from 0 to 28. Duplicate bus addresses are also
		not permitted within a GBC group. However, each block in the group uses
		the same serial bus address on its respective bus.
GFK-0787B	Chapter 6 Configuration		6-33