Getting Started

Communications

The XiII printer has been designed with flexible communication capabilities that allow the printer to be interfaced to a variety of controlling devices. A single DB25 connector includes all signals necessary for interfacing the printer to RS-232, RS-422, or RS-485 serial data communication devices at data rates from 110 to 57,600 baud. Baud rate, parity, data length, number of stop bits, and handshaking protocol are programmable via the front panel display and keypad.

A parallel data communication port is also provided. This port allows data to be sent to the printer at a higher speed than serial communications and still permits printer status information to be sent back to the host via the RS- 232 serial port.

CAUTION: Zebra printers comply with international regulations governing radiated emissions when using fully shielded data cables. Data cables must be fully shielded and fitted with metal or metalized connector shells. Shielded data cables and connectors are required to prevent radiation and reception of electrical noise. Use of unshielded data cables may increase radiated emissions above the regulated limits.

Loading Media

Introduction to Media Loading

Note: A Calibration must be performed when media and ribbon (if used) are first installed in the printer and when a different type of media or ribbon is installed. See “Media and Ribbon Sensor Calibration” on page 38.

Note: Media widths and thicknesses vary between applications. To maintain print quality from one application to another, refer to “ Adjustments” on page 61.

Zebra XiII Printer User’s Guide

7