Getting Started

4.Slide the upper sensor along the slot to the desired position. When using label stock that has a gap between labels (die-cut labelstock), position the media sensor anywhere along the gap EXCEPT where the rounded corners of the label are detected. When using tagstock, position the upper sensor directly over the hole or notch.

5.Tighten the screw.

Figure 5. Lower Media Sensor Adjustment

Lower Media Sensor Adjustment

Refer to Figure 5 throughout this procedure.

1.Locate the Lower Media Sensor assembly (a spring clip holding a circuit board) near the bottom rear of the printhead assembly.

2.Position the sensor by sliding it in its slot so that the two brass-colored infrared emitters are centered under the upper sensor.

3.If you are moving the sensor away from the printer’s main frame: Gently pull wires out of the printer frame as required. (Wires should have a little slack.) Call a service technician if there is not enough slack

Zebra XiII Printer User’s Guide

17