Getting Started

Figure 4. Upper Media Sensor Adjustment

Adjusting the Upper Media Sensor Position

Note: If you own a 140XiII or 170XiII printer and need to move the sensor to the outside half of the maximum media width, or from the outside half to the inside half, contact a service technician to perform this procedure because it will require additional steps which are beyong the scope of this user’s guide.

To adjust the upper media sensor, follow these steps.

1.Remove ribbon if it is installed.

2.Locate the Upper Media Sensor. Refer to Figure 4. The Upper Media Sensor is directly below the adjustment screw head.

3.Loosen the Upper Media Sensor Adjustment screw (Phillips head).

16

Zebra XiII Printer User’s Guide