Guide User’s Printer IIXi Zebra
41
E K A H S D N A H T S O H
L
O
C
O
T
O
R
P
ID
K
R
O
W
T
E
N
Setting Host Handshake 
Press the right or left oval key to display other choices.
Default: XON/XOFF Selections: XON/XOFF, DTR/DSR
The handshake protocol of the printer must match the handshake protocol of the host for communications to take place. Select the handshake protocol that matches the one being used by the host.
Setting Protocol 
Press the right or left oval key to display other choices.
Default: None Selections: None, Zebra, ACK/NACK
Protocol is a type of error checking system. Depending on the selection, an indicator may be sent from the printer to the host signifying that data has been received. Select the Protocol that is requested by the host. Further details on Protocol can be found in the ZPL IIProgramming Guide, available from Zebra Technologies Corporation.
Note: Zebra is the same as ACK/NACK except that with Zebra the response messages are sequenced.
Note: If Zebra is selected, printer must use “DTR/DSR” host handshake protocol.
Setting Network ID 
Press the left oval key to move to the next digit position, press the right oval key to increase the value of the digit.
Default: 000 Range: 000 - 999
Network ID is used to assign a unique number to a printer used in a network. This gives the host the means to address a specific printer. If the printer is used in a network, you must select a Network ID number.
Operation