36

Guide User’s Printer IIXi Zebra

H

T

ID

W

T

IN

R

P

M U IM X A M

H T G N E L

Listing Printer Information

S

T

N

O

F

T

IS

L

S

E

D

O

C

R

A

B

T

IS

L

Setting Print Width Press the right oval key to increase the value, press the left oval key to decrease the value. To change the unit of measurement, press the left oval key until the unit of measurement is active, then press the right oval key to toggle to a different unit of measure (inches, mm, or dots).

Default:, Range: The default and range of acceptable values varries depending on what printer you have. Refer to “Printing Specifications” on page 85 for further information about the ranges available for your model.

Select a print width that is closest to your media, but AT LEAST as wide. Print width tells the printer the width of the media you are using. Setting width too narrow may result in unprinted portions of your label format. Setting width too wide wastes formatting memory and may cause printing off the right side of the label.

Setting Maximum Length Press the left oval key to decrease the value, press the right oval key to increase the value.

Default, Range: The default and range of acceptable values varries depending on your printer’s configuration. Values are adjustable in 1.0 inch (25.4 mm) increments.

Maximum Length is used in conjunction with the Calibration procedure. The value of this setting determines the maximum label length that will be used during the media portion of the calibration process. Only a few labels are required to set media sensors. Always set the value that is closest to, but not lower than, the length of the label you are using. For example, if the length of the label is 14.5 inches, set the parameter for 15.0 inches (381 mm).

List Fonts Press the right oval key to print a label listing all of the available fonts.

This selection is used to print a label that lists all of the fonts currently available in the printer, including standard printer fonts plus any optional fonts. Fonts may be stored in RAM, in Font EPROMs, or on Font Cards.

List Bar Codes Press the right oval key to print a label listing all of the available bar codes.

This selection is used to print a label that lists all of the bar codes currently available in the printer.

Operation