Getting Started
8.Media loading is now complete. See “Adj usting the Transmissive Media Sensor Assembly Position” on page 15.
Rewind Mode for Printers With the Cutter Option
1.Remove the Media Rewind Plate from its storage location in front of the print mechanism inside the media compartment.
2.Invert the Rewind Plate so that the lip on the attached Hook Plate points down.
3.Insert the Hook Plate lip a short distance (½") into the lower opening in the Side Plate and slide the Rewind Plate in so that it stops against the printer’s main frame.
4.Insert the two small tabs on the Rewind Plate into the corresponding slots in the Cutter Support Bracket. (The Rewind Plate should spring into the proper position.)
5.Load the media as described in the instructions for Roll Media Loading on page 10.
6.Remove the Hook from the Rewind Spindle.
7.Route the media as shown in Figures 1 and 2 and wind it once or twice around either (1) the Rewind Spindle and reinstall the Hook, or (2) a 3” core.
8.Media loading is now complete. See “Adj usting the Transmissive Media Sensor Assembly Position” on page 15.
Zebra XiII Printer User’s Guide | 13 |