Getting Started

Roll Media Loading

Place the media roll on the Media Supply Hanger and thread the media through the printhead assembly as shown in the “Tear-Off” loading part of Figure 2. Flip up the Media Supply Guide and adjust the Media Supply Guide and the Media Guide against the outer edge of the media. These guides must not cause pressure or excessive drag on the media. Close the Printhead Open Lever and see “Adjusting the Transmissive Media Sensor Assembly Position” on page 15.

Figure 2. Roll Media Loading

Fanfold Media Loading

Fanfold media, from outside the printer, feeds through either the bottom or rear access slot. You may also use the Fanfold Supply Bin to hold media inside the printer housing.

10

Zebra XiII Printer User’s Guide