13.OUTDOOR ANTENNA GROUNDING - If an outside antenna or cable system is connected to the video unit, be sure the antenna or cable system is grounded to provide some protection against voltage surges and built-up static charges. Section 810 of the National Electrical Code, ANSI/NFPA No. 70-1984, provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size

of grounding conductors, location of antenna- discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

ANTENNA

LEAD-IN

WIRE

GROUND

CLAMP

ANTENNA

DISCHARGE

UNIT (NEC

ELECTRICSECTION 810-20)

SERVICE

EQUIPMENT

GROUND

GROUNDING CONDUCTORS

CLAMPS

(NEC SECTION 810-21)

POWER SERVICE GROUNDING

NEC - NATIONAL ELECTRICAL CODE ELECTRODE SYSTEM (NEC ART 250, PART H)

14.LIGHTNING - For added protection of this video unit during a lightning storm, or when it is left unat- tended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the video unit due to lightning and power line surges.

15.POWER LINES - An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, where it can fall into such power lines or circuits. When installing an outside antenna system extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

16.OVERLOADING - Do not overload wall outlets and extension cords as this can result in the risk of fire or electric shock.

17.OBJECTS AND LIQUIDS - Never push objects of any kind into this video unit through openings as they may touch dangerous voltage points or short out parts that could result in a fire or electric shock. Never spill liquids of any kind onto the unit. Should spillage occur, unplug unit and have it checked by a techni- cian before use.

18.SERVICING - Do not attempt to service this video unit yourself as opening or removing covers may expose you to a dangerous voltage or other hazards. Refer all servicing to qualified service personnel.

19.DAMAGE REQUIRING SERVICE - Unplug this video unit from the wall outlet and refer servicing to qualified service personnel under the following conditions:

a.When the power supply cord or plug is damaged.

b.If any liquid has been spilled onto or objects have fallen into the video unit.

c.If the video unit has been exposed to rain or water.

d.If the video unit does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions. Improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the video unit to its normal operation.

e.If the video unit has been dropped or the cabinet has been damaged.

f.When the video unit exhibits a distinct change in performance — this indicates a need for service.

20.REPLACEMENT PARTS - When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer.

21.SAFETY CHECK - Upon completion of any service or repairs to this video unit, ask the service technician to perform safety checks to determine that the video unit is in proper operating condition.

22.HEAT - This video unit should be situated away from heat sources such as radiators, stoves, or other products (including amplifiers) that produce heat.

W A R N I N G

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

DO NOT OPEN THE CABINET; DANGEROUS HIGH VOLTAGE IS PRESENT. REFER SERVICING TO QUALIFIED PERSONNEL ONLY.

THIS VIDEO CASSETTE RECORDER SHOULD ONLY BE USED WITH 120V, 60HZ (STANDARD U.S. HOUSEHOLD) CURRENT.

FEDERAL LAW PROVIDES SEVERE CIVIL AND CRIMINAL PENALTIES FOR THE UNAUTHORIZED REPRODUCTION, DISTRIBUTION, OR EXHIBITION OF COPYRIGHTED MOTION

PICTURES AND VIDEOTAPES. (TITLE 17, UNITED STATES CODE, SECTIONS 501 AND 506.)

USER/INSTALLER CAUTION:

Your authority to operate this FCC certified equipment could be voided if you make changes or modifications not expressly approved by the manufacturer, who is respon- sible for compliance with Part 15 FCC rules.

NOTE TO CATV SYSTEM

INSTALLER:

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the National Electronic Code that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

ii2 DISCOVER THE DUAL-DECK DIFFERENCE

Page 4
Image 4
Go-Video 4-Head Hi-Fi, VHS-VHS manual R N I N G