CHAPTER 2 - OPERATING YOUR DUAL-DECK VCR 17
Setting Antenna& Channel Memory
Once you have your Dual-Deck VCR hooked up to your
antenna or directly to a cable system without a cable
converter box, you’ll need to set the antenna and the
channel memory. If you are using a cable converter
box, you will need to set your VCR’s tuner channel to
receive only the cable converter box output channel.
Your Dual-Deck VCR comes with a 181 channel MTS
tuner capable of receiving both over-the-air and cable
broadcasts in stereo. Reception for channels 2-13 are
the same on regular broadcast or on cable TV. But
above channel 13, cable TV (CATV) reception is
different from broadcast TV.
1. Press
MENU
on your remote control. The Features
menu will appear.
2. Press
1
. The Setup menu will appear.
3. Press
2
. The Tuner Setup menu will appear.
4. Set the ANTENNA SOURCE. Press CHANGE to
cycle between TV and CATV (cable). When the
desired option is on the screen, go to step 5.
5. Press
SELECT
(Mute button) to move to
AUTO PROGRAM.
6. Press
CHANGE
(LCV button) to begin automatic
channel programming. The VCR will go through
all possible TV or cable channels, and will auto-
matically put the channels which you receive
into Channel Memory. This will take a few
minutes to complete.
7. If you wish, you can program certain channels into
Channel Memory or remove them from Channel
Memory manually. You can also select stereo
sound. To do this, see the TUNER SETUP menu
section of this manual. See page 35.
8. Press
MENU
to save the changes and to exit to
the SETUP menu.
9. Press
MENU
until you exit the menu system.
NOTE:
In cases of poor or weak video
reception, your Tuner Setup menu may
not be visible. When this happens, select
a strong local channel where the
menu will be visible again.
#
#