* NOTE:
If you press MENU and do not get the Features menu, continue pressing MENU until you see the Features menu.
Features menu
Copy Mode [Menu, 2]*
HQ Copy uses
Optimum results will be obtained when using HQ1 if the source tape is in SP or any tape with Copy Guard.
For source tapes in EP or LP without Copy Guard, use HQ2 for best results.
1.Press 2 to select this item. Subsequent pressings of this number will switch this selection between HQ1 and HQ2 modes.
You can also use SELECT (Mute button) to highlight this item and CHANGE (LCV button) to change this feature.
2.When the desired setting is shown on the screen, either press MENU to exit this menu or move to another item.
NOTE:
If this feature is OFF, check the record speed on Deck Two before copying a tape to be sure it is set as you want it.
Speed Matching [Menu, 3]*
Speed matching automatically sets the record speed to be the same as the current playback tape. You will get the best quality copy when this feature is turned ON.
1.Press 3 to select this item. Subsequent pressings of this number will turn this feature ON or OFF.
You can also use SELECT (Mute button) to highlight this item and CHANGE (LCV button) to change this feature.
2.When the desired setting is shown on the screen, either press MENU to exit this menu or move to another item.
Copy Audio Insert [Menu, 4]*
The
When Copy Audio Insert is ON, the audio signal comes from your AUX IN input source (Audio In jack on the Front Panel) instead of from the tape in Deck one being copied.
1.Press 4 to select this item. Subsequent pressings of this number will cycle this feature between ON and OFF.
You can also use SELECT (Mute button) to highlight this item and CHANGE (LCV button) to change this feature.
CHAPTER 3 - PROGRAMMING YOUR
