System Errors
Alarm Troubleshooting
Alarm and Description | Cause | Solution |
|
|
|
CA | The CAN cable between the Display Mod- | Verify that the cable is correctly |
Communication Error | ule and the Advanced Fluid Control Module | connected. |
The Display Module is not | is not connected. |
|
communicating with the |
|
|
The CAN cable is cut or bent. | Verify that the cable has not been cut | |
Advanced Fluid Control |
| or bent at a radius smaller than 1.6 in. |
Module. |
| (40 mm). |
|
|
|
| The cable or connector failed. | Replace cable. |
|
|
|
| Alternator Powered Systems: | 1. For any module that does not |
| Check that the Advance Fluid Control Mod- | have power, disconnect and |
| check the voltage on the cable | |
| ule (AFCM), Display Module (DM), and | produced by the alternator mod- |
| USB Module have power (green LED) and | ule (See Alternator Module Power |
| are communicating (amber LED blinking) | Output). If the proper voltage is |
|
| not detected, troubleshoot the |
|
| Alternator Module. |
|
| 2. If the proper voltage is detected, |
|
| verify the cable connecting the |
|
| two modules is good. |
|
| 3. If the cable is good, replace the |
|
| module. |
|
|
|
| There may be a short in one of the sole- | Replace the cable (16E890) |
| noid/meter cables connected to the AFCM. |
|
|
|
|
| The AFCM power supply may be bad, as | Replace the module. |
| indicated by the status LEDs (red, yellow, |
|
| green) being off. Verify the power supply |
|
| works by disconnecting from the AFCM and |
|
| connecting to another module, either the |
|
| Display Module or USB Module. |
|
|
|
|
| The DM and the AFCM have different ver- | Install the latest software from token |
| sions of software installed. | kit 16D922 on all modules. |
|
|
|
| The red LED on the AFCM is on. | If on solid, replace module. |
|
| If blinking, contact your distributor. |
|
|
|
| NOTE: |
|
| 1. If the AFCM loses communication (no flickering amber LED) but then comes | |
| back on the alarm will auto clear and will not log the alarm. | |
| 2. If the DM loses communication (no flickering amber LED) but then comes back | |
| on you will have to manually clear the alarm and there will be an alarm log. | |
| 3. If the USB module loses communication (no flickering amber LED) but then | |
| comes back on you will not get an alarm. | |
|
|
|
CAU1 | The module has been removed. | Put system in standby and install the |
USB Communication Error |
| USB Module. |
The system detected a USB |
|
|
The cable is disconnected or broken. | Put system in standby and reconnect | |
Module at last power up, but |
| or replace the USB cable. |
does not detect it currently. |
|
|
3A0868G | 53 |
