Graco 3A1705J important safety instructions Setup ADM. Advanced Display Module ADM Operation

f.Open fluid inlet valves (FV). Check for leaks.

Do not mix components A and B during startup. Always provide two grounded waste containers to keep component A and component B fluids separate.

g.Hold gun fluid manifold over two grounded waste containers. Open fluid valves A and B until clean, air-free fluid comes from valves. Close valves.

The Fusion AP gun manifold is shown.

14.Setup ADM. Advanced Display Module (ADM) Operation, page 43.

15.Press to turn on hose heat zone.

Startup

This equipment is used with heated fluid which can cause equipment surfaces to become very hot. To avoid severe burns:

•Do not touch hot fluid or equipment.

•Do not turn on hose heat without fluid in hoses.

•Allow equipment to cool completely before touching it.

•Wear gloves if fluid temperature exceeds 110°F (43°C).

Thermal expansion can cause overpressurization, resulting in equipment rupture and serious injury, including fluid injection. Do not pressurize system when preheating hose.

16.Wait for the engine to reach operating temperature and the hose to reach setpoint temperature. The engine has reached operating temperature when the black arrow is under the green area of the temperature bar. The radiator fan will turn on when operating temperature is reached.

17.Wait for the hose to reach set point temperature or a hose overpressure condition may occur due to thermal expansion.

18.Press to turn on A and B heat zones.

3A1705J 57