Proportioner Models

Proportioner Models

E-30i Series

Includes:Part Available
Auxiliary
Current at
240 V, 60
Hz*
Booster
Heat
(4000
Watts)
Air
Compressor
(5000 Watts)
Voltage
(phase)
Total
System
Load †
(Watts)
Max Flow
Ratelb/min
(kg/min)
Approxi-
mate Out-
put per Cy-
cle (A+B)
gal. (liter)
Maximum
Fluid
Working
Pressure
psi (MPa,
bar)
259079 50 Amps 240 V (1) 7,700 30(13.5) 0.0272
(0.1034)
2000 (13.8,
138)
259080 32 Amps 240 V (1) 11,700 30 (13.5) 0.0272
(0.1034)
2000 (13.8,
138)
259089 30 Amps 240 V (1) 7,700 30 (13.5) 0.0272
(0.1034)
2000 (13.8,
138)
259090 12 Amps 
240 V (1) 16,700 30 (13.5) 0.0272
(0.1034)
2000 (13.8,
138)

E-XP2i Series

Includes:Part Available
Auxiliary
Current at
240 V, 60
Hz*
Booster
Heat
(4000
Watts)
Air
Compressor
(5000 Watts)
Voltage
(phase)
Total
System
Load †
(Watts)
Max Flow
Rate gpm
(lpm)
Approxi-
mateOutput
per Cycle
(A+B) gal.
(liter)
Maximum
Fluid
Working
Pressurepsi
(MPa, bar)
259081 32 Amps 240V (1) 11,700 2.0 (7.6) 0.0203
(0.0771)
3500 (24.1,
241)
259091 12 Amps 
240 V (1) 16,700 2.0 (7.6) 0.0203
(0.0771)
3500 (24.1,
241)

Total system watts used by system, based on maximum heated hose lengthof 310ft(94.5m)for

each unit.

* Full load amps available for auxiliary equipment when all bare-syste m components are operating

at maximum capabilities. Available auxiliary c urrent is based on 310 ft (94.5 m) of heated hose.

An additional 3.0 amps of auxiliary current is available for each 50 ft (15.2 m) section of heated

hose that is not used.

Available auxiliary current will be less when the engine is de-rated for site altitude. Reduce the

Available Auxiliary Current in the chart by 2.5 Amps per 1000 ft (300 m) elevation increments. If th e

available auxiliary current is less than zero, the system configuration may not support the full load

at that altitude.

Includes Complete Air Compressor Kit 24K335.

Refer to Circuit Breaker Configuration Options, page 29.

SeeApprovals, page 10.

3A1705J 9