Graco 3A1705J Error Codes and Troubleshooting, Error Type Name Cause Solution Code Location

Troubleshooting

Troubleshooting

See Errors, page 73 for information about errors that can occur on the system.

See Troubleshooting, page 53 for the ten most recent errors that have occurred on the system. See Troubleshoot Errors, page 73 to diagnose errors on the ADM that have occurred on the system.

See Error Codes and Troubleshooting for error codes, possible causes, and solutions.

Note

Error codes are stored in the error log and displayed on the Error and Troubleshooting screens on the ADM.

Error Codes and Troubleshooting

See Reactor repair manual for non-error based troubleshooting.

Error	Error	Type	Name	Cause	Solution
Code	Location
A1NM	MCM	ALARM	No Motor	Loose or bad motor or	Check for tight motor
			Current	wire connection.	wire termination in green
					connector. If loose,
					contact Graco distributor
					for rework instructions.
					Check for tight motor
					brush wire terminal screw.
					See system repair manual.
				Motor brushes	Check motor brushes and
				completely worn down.	replace if needed.
				Bad MCM.	Replace MCM. See
					system repair manual.

74 3A1705J