Graco 3A1705J Advanced Display Module ADM Operation, Advanced Screen 3- USB

Advanced Display Module (ADM) Operation

Advanced Display Module (ADM) Operation

When main power is turned on by turning the main power switch (MP) to the ON position, the splash screen will be displayed until communication and initialization is complete.

Then the power key icon screen will display until the

ADM power on/off button (A) is pressed for the first time after system power-up.

To begin using the ADM, the machine must be active. To verify the machine is active, verify that the System Status Indicator Light (B) is illuminated green, see Advanced Display Module (ADM), page 19. If the System Status Indicator Light is not green, press

the ADM Power On/Off (A) button . The System Status Indicator Light will illuminate yellow if the machine is disabled.

Perform the following tasks to fully setup your system.

1.Select pressure for the Pressure Imbalance Alarm to activate. See System Screen , page 47.

2.Enter, enable, or disable recipes. See Recipes Screen, page 47.

3.Set general system settings. See Advanced Screen 1 — General, page 46.

4.Set units of measure. See Advanced Screen 2 — Units, page 46.

5.Set USB settings. See

Advanced Screen 3— USB, page 46.

6.Set target temperatures and pressure. See Targets, page 50.

7.Set component A and component B supply levels. See Maintenance, page 51.

8.Ensure engine is at operating temperature on the home screen.

3A1705J 43