Two Discrete Lengths (Parameter L2)

This option decodes only those codes containing two selected lengths. For example, when you want to scan only I 2 of 5 symbols containing 6 or 14 characters, scan the “I 2 of 5 Two Discrete Lengths” bar code and then “0”, “6”, “1” and “4” bar codes to decode only I 2 of 5 symbols containing 6 or 14 characters. Use the Keypad Number Symbols (page 4-72)at the end of this section.

To begin setting two discrete lengths, scan this “I 2 of 5 Two Discrete Lengths” bar code:

Next, scan four numeric bar codes that correspond to the desired value. Single digit numbers must have a leading zero. If you wish to change your number selection, scan Cancel on the Keypad Number Symbols page.

Length Within Range

This option decodes a code type within a specified minimum and maximum range. For example, when you want to scan only I 2 of 5 symbols containing between 4 and 12 characters, scan the “I 2 of 5 Length Within Range” bar code and then “0”, “4”, “1” and “2” bar codes using the Keypad Number Symbols (page 4-72)at the end of this section.

To begin setting lengths within a range, scan this “I 2 of 5 Length Within Range” bar code:

Next, scan numeric bar codes that correspond to the desired value. Single digit numbers must have a leading zero. If you wish to change your number selection, scan Cancel on the Keypad Number Symbols page.

Any Length

This option decodes I 2 of 5 bar codes containing any number of characters.

Note: Important: Selecting this option may lead to misdecodes for I 2 of 5 codes.

To set any length, scan this “I 2 of 5 Any Length” bar code:

See Also: Set Lengths for I 2 of 5 (superseded) (page 4-70)

4 - 46